HP E1351A/53A Manuel d'utilisateur télécharger pdf (Page 24)

Connecting Field Wiring

Leads for the individual channels are connected through the channel

terminals on the terminal modules. Multimeters and signal generators can

be connected to the direct terminals or tree terminals on the terminal

modules. Figure 2-9 shows the terminal module channel terminals for the

16-Channel FET Multiplexer Module (HP E1351A) and the 16-Channel

Thermocouple FET Multiplexer Module (HP E1353A).

Wiring Guidelines • If possible, use shielded cables with the shields connected to the Guard

(G) terminals and to the low connection near the measurement point.

• Be sure the wires make good connections on the screw terminals.

• For thermocouples, connect the Guard terminal to the

thermocouple’s shield lead and the low connection near the

measurement point.

Figure 2-9. FET Multiplexer Modules Terminal Module

24 Configuring the HP E1351A/53A FET Multiplexer Modules Chapter 2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 106 107

Pas de commentaire

HP E1351A/53A Manuel d'utilisateur Page 24