HP Server rp7400 Manuel d'utilisateur télécharger pdf (Page 20)

susceptible to EMI problems.

To remove the back air baffle from the:

a. Loosen the two captive mounting screws at the support

bridge.

b. Grasp the air baffle along the extruded handle on the back

edge of the air baffle and lift it out of the SPU.

Step 6. Remove the Memory Carrier

The memory carriers (up to four) are located along the back of

the SPU.

CAUTION Be sure to have an anti-static pad or ESD compliant work

place to rest the memory carrier on.

To remove the memory carrier from the SPU:

a. Grasp the insertion/extractor levers on the appropriate

memory carrier and pull them up to disengage the memory

carrier form the system board.

b. Carefully pull the memory carrier out of the SPU.

Step 7. Install the Memory DIMMs in the Memory Carrier

The memory DIMM resides in slots located on the memory

carrier. The memory DIMMs are loaded in DIMM pairs.

Memory DIMMs are keyed and only install into a memory

carrier one way. Memory DIMMs are only installed in matched

(memory size) pairs. Be sure the memory DIMM being

installed is matched to the appropriate DIMM in the pair slot.

To add a memory DIMM in the memory carrier:

a. Align the memory DIMM over the correct memory carrier

slot. Be sure the extractor levers are in the open position

(angled out from the memory slot).

b. Firmly and evenly (pressure on both ends of the memory

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Pas de commentaire

HP Server rp7400 Manuel d'utilisateur Page 20