HP Server rp7400 Manuel d'utilisateur télécharger pdf (Page 23)

the front of the SPU sticks out approximately 2 to 4 inches.

NOTE It is recommended that you push the SPU from the back of

the cabinet. This allows you to monitor the cable

movement to avoid snags and tangles with other SPUs

or cables.

c. Align the left and right bezel bracket key slots over the

three bracket screws on each side of the SPU.

d. Slide the bezel brackets down and tighten the six (three on

each side) bracket screws.

e. Carefully push the SPU back into the cabinet until the

bezel brackets contact the cabinet vertical rails.

f. Insert the four (two on each side, T25) SPU retainer

screws, located just below and above bezel snap tabs.

Check all cables to be sure none have been loosened during the

previous procedure. Close or replace the rear door.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

HP Server rp7400 Manuel d'utilisateur Page 23