HP Server rp7400 Manuel d'utilisateur télécharger pdf (Page 30)

e. Insert the four (two on each side, T25) SPU retainer screws, located just below and above

bezel snap tabs.

Check all cables to be sure none have been loosened during the previous procedure. Close or

replace the rear door.

Step 8. Replace the Front Bezel

To replace the front bezel, perform the following steps:

a. Align the front bezel over the front of the SPU.

b. Press the front bezel onto the cabinet until it snaps into place.

Step 9. Power the System On

CAUTION Before applying A.C. power to an rp7400 computer, be sure all covers and cooling fans are

properly installed. Failure to perform this check could result in decreased computer

component life and reliability.

a. Be sure all connected peripherals are on, with no errors or faults indicated.

b. Be sure the SPU power switch is in the standby (0) position.

CAUTION When the power cords are connected to the SPU, there will be power present inside the SPU

chassis, even with the power switch in the standby position.

c. Carefully insert the A.C. power cords (3) into the line filter receptacles at the back of the SPU.

NOTE Be sure to plug all three power cords into the back of the SPU. Also be sure the cabinet PDU

is plugged into an appropriate wall outlet.

d. Put the power switch in the on (|) position. At this time you will hear the cooling fans coming

up to speed and being synchronized. This creates a high pitched squeak for a few seconds. The

fans should drop to normal speed within a few seconds. If not check the front panel or console

for fault indications.

e. Check all front panel LEDs for normal indications, with no warnings ar faults indicated.

The SPU should take a few minutes to perform all selftests and initialization routines. At the

end of this you should be able to launch the operating system or initiate other software routines.

Step 10. Verify the Procedure

Run the ioscan utility to ensure the system recognizes the I/O card.

1 2 ... 25 26 27 28 29 30 31

Pas de commentaire

HP Server rp7400 Manuel d'utilisateur Page 30