HP Server rp7400 Manuel d'utilisateur télécharger pdf (Page 24)

Step 12. Replace the Front Bezel

To replace the front bezel, perform the following steps:

a. Align the front bezel over the front of the SPU.

b. Press the front bezel onto the cabinet until it snaps into

place.

Step 13. Power the System On

CAUTION Before applying A.C. power to an rp7400 computer, be sure

all covers and cooling fans are properly installed. Failure

to perform this check could result in decreased computer

component life and reliability.

a. Be sure all connected peripherals are on, with no errors or

faults indicated.

b. Be sure the SPU power switch is in the standby (0)

position.

CAUTION When the power cords are connected to the SPU, there will

be power present inside the SPU chassis, even with the

power switch in the standby position.

c. Carefully insert the A.C. power cords (3) into the line filter

receptacles at the back of the SPU.

NOTE Be sure to plug all three power cords into the back of the

SPU. Also be sure the cabinet PDU is plugged into an

appropriate wall outlet.

d. Put the power switch in the on (|) position. At this time

you will hear the cooling fans coming up to speed and being

synchronized. This creates a high pitched squeak for a few

seconds. The fans should drop to normal speed within a few

seconds. If not check the front panel or console for fault

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

HP Server rp7400 Manuel d'utilisateur Page 24