HP 10TB Guide de l'utilisateur télécharger pdf (Page 102)

3. Remove all eight screws from the front bezel (1, Figure 77 (page 102)), and then lift the front

bezel up and out to remove the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Figure 77 Removing the front bezel

Replacing the front bezel

1. Install the replacement front bezel with the handle at a 90 degree angle making sure the

bottom pins are aligned with the bottom holes (1, Figure 78 (page 102)), and replace the

screws into the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Figure 78 Replacing the front bezel

2. Push the drive drawer back into the system enclosure.

3. Power on the system by pressing the power button ON.

4. Verify that the replacement component is working properly by checking the associated LED

status.

5. Confirm that the system has resumed normal operations.

102 Removing and replacing hardware components

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 180 181

Pas de commentaire

HP 10TB Guide de l'utilisateur Page 102