HP 10TB Guide de l'utilisateur télécharger pdf (Page 107)

Replacing the front LED display board (full)

1. Complete the following (Figure 85 (page 107)):

a. Install the replacement LED display board (1).

b. Replace the four LED display board screws (2).

c. Reconnect the LED display board to the drive drawer (3).

Figure 85 Installing the front LED display board

2. Replace the front bezel as described in “Replacing the front bezel (full)” (page 104).

Removing and replacing a drive drawer

Removing the drive drawer

1. Verify the failed component as described in “Verifying component failure” (page 82).

2. Power off the system as described in “Powering the system off and on” (page 76).

3. Remove the enclosure as described in “Removing the system enclosure from the rack” (page 83).

4. Remove the top back panel by pressing the panel release button and lifting the latch to slide

the top back panel off.

5. Remove the hard drive fan module (Figure 86 (page 107)).

Figure 86 Removing the fan module

6. Push up on the SAS I/O module release button (1, Figure 87 (page 108)).

7. Push down on the SAS I/O module lever (2, Figure 87 (page 108)), and then remove the SAS

I/O module (3).

NOTE: This step may require significant force to accomplish.

Removing and replacing a drive drawer 107

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 180 181

Pas de commentaire

HP 10TB Guide de l'utilisateur Page 107