HP 10TB Guide de l'utilisateur Page 122

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 181
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 121
Replacing the enclosure rails
1. Align the replacement rail, and then attach it by sliding the rail toward the front of the enclosure
(Figure 115 (page 122)).
Figure 115 Installing the enclosure rails
2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive
drawer partially back into the system enclosure so that approximately two inches of the drawer
is still out of the enclosure (Figure 116 (page 122)).
CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect
the power coil assembly to prevent damaging the power coil assembly.
Figure 116 Partially installing the drive drawer
3. Pull the cable slightly out of the coil power plug and connect it to the midplane board
(Figure 117 (page 123)).
122 Removing and replacing hardware components
Vue de la page 121
1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 180 181

Commentaires sur ces manuels

Pas de commentaire