HP PROCURVE 6600 Manuel d'utilisateur télécharger pdf (Page 338)

100

101

Port Trunking

Web: Viewing Existing Port Trunk Groups

Caution Unless spanning tree is running on your network, removing a port from a trunk

can result in a loop. To help prevent a broadcast storm when you remove a

port from a trunk where spanning tree is not in use, ProCurve recommends

that you first disable the port or disconnect the link on that port.

Syntax: no interface < port-list > lacp

Removes < port-list > from any dynamic LACP trunk and

returns the ports in < port-list > to passive LACP.

In this example, port C6 belongs to an operating, dynamic LACP trunk. To

remove port C6 from the dynamic trunk and return it to passive LACP, you

would do the following:

ProCurve(config)# no interface c6 lacp

ProCurve(config)# interface c6 lacp passive

Note that in the above example, if the port on the other end of the link is

configured for active LACP or static LACP, the trunked link will be re-

established almost immediately.

Web: Viewing Existing Port Trunk

Groups

While the web browser interface does not enable you to configure a port trunk

group, it does provide a view of an existing trunk group.

To view any port trunk groups:

Click on the Status tab.

Click on

[Port Status].

12-18

1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 853 854

Commentaires sur ces manuels

Pas de commentaire

HP PROCURVE 6600 Manuel d'utilisateur Page 338

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel HP PROCURVE 6600