Hp StorageWorks 1510i Modular Smart Array Manuel d'utilisateur télécharger pdf (Page 55)

1. In the SMU, select Target > CHAP Settings.

2. Expand the CHAP State drop-down box and change the setting to Enabled.

NOTE:

If CHAP settings have already been entered for this target, the display is contracted and

protected by a gateway check box. To change existing CHAP settings, clear the Use

Existing CHAP Settings check box. The page expands, allowing access to the settings.

3. Enter the CHAP Secret.

4. On the server, open the iSCSI initiator software utility. Navigate through the iSCSI utility and enter

thesameCHAPsecretassignedintheSMU.

Setting up mutual CHAP authentication

Setting up mutual CHAP authentication between an initiator and a target requires:

• Entering a target-speciﬁcCHAPsecretinboththeSMUandtheiSCSIinitiatorsoftwareutility.

• Entering an initiator-speciﬁc CHAP secret in both the SMU and the iSCSI initiator software utility.

• Enabling mutual authentication in the iSCSI initiator software utility.

1. To enter a target-speciﬁc CHAP secret in both the SMU and the iSCSI initiator software utility, see

“Setting up target-speciﬁc initiator-to-target CHAP authentication” on page 54.

HP Storage Management Utility user guide

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 98 99

Pas de commentaire

Hp StorageWorks 1510i Modular Smart Array Manuel d'utilisateur Page 55