HP ProDesk 600 G3 Base Model Small Form Factor PC Manuel d'utilisateur télécharger pdf (Page 45)

Installing a 9.5 mm slim optical drive

1. Prepare the computer for disassembly (Preparation for disassembly on page 20).

2. Remove the access panel (Access panel on page 21).

3. If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel and

then remove the bezel blank. See Bezel blank on page 23 for more information.

4. Align the small pin on the release latch with the small hole on the side of the drive and press the latch

rmly onto the drive.

5. Slide the optical drive through the front bezel all the way into the bay (1) so that the latch on the rear of

the drive locks into place (2).

Drives 37

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 149 150

Pas de commentaire

HP ProDesk 600 G3 Base Model Small Form Factor PC Manuel d'utilisateur Page 45