6. Connect the power cable (1) and data cable (2) to the rear of the drive.
7. Connect the opposite end of the data cable to the light blue SATA connector on the system board labeled
SATA1.
NOTE: Refer to System board connections on page 33 for an illustration of the system board drive
connectors.
Removing and replacing a 3.5-inch hard drive
CAUTION: All removable media should be taken out of a drive before removing the drive from the computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Disconnect the data cable (1) and power cable (2) from the rear of the hard drive.
IMPORTANT: When removing the cables, pull the tab or connector instead of the cable itself to avoid
damaging the cable.
38 Chapter 4 Removal and replacement procedures: Small Form Factor
Commentaires sur ces manuels