Hp 3300mfp Manuel d'utilisateur télécharger pdf (Page 51)

EN Printing custom-sized media or card stock 49

Printing custom-sized media or card stock

HP LaserJet 3300 series products can print on custom-sized media or card stock between 76 by

127 mm. (3 by 5 inches) and 216 by 356 mm. (8.5 by 14 inches). Depending on the media, you

can print up to 10 sheets from the priority input tray. Use the main input tray for more than 10

sheets.

Note Make sure that the sheets are not stuck together before you load them.

To print custom-sized media or card stock

1 Open the straight-through output door.

2 Load the media with the narrow side forward and the side to be printed facing up. Adjust the

side and rear media guides to fit the media.

3 Select the correct size in the printer settings. (Software settings can override printer

properties.)

4 If printing on card stock, access the optimizing feature from the Paper tab in your Windows

printer driver. Then select Optimize for: and choose Card stock from the drop-down list.

5 Print the document.

Printing on both sides of the media (manual duplexing)

To print on both sides of the media (manual duplexing), you must run the media through the printer

twice. You can print using the normal output path or the straight-through output path.

Hewlett-Packard recommends that you use the normal output path for lightweight paper and use

the straight-through output path for any heavy media or media that curls when printed.

See the following topics for more information:

To duplex manually on lightweight media

To duplex manually on heavy media or card stock (straight-through output path)

Note Manual duplexing is supported only in Windows.

Manual duplexing can cause the product to become dirty, reducing print quality. If the product

becomes dirty, see Cleaning and maintenance

for instructions.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 258 259

Pas de commentaire

Hp 3300mfp Manuel d'utilisateur Page 51