Hp NonStop G-Series Manuel d'utilisateur télécharger pdf (Page 156)

The 5157/5157 ACL S-Series Subsystems Installation/Users Guide

Appendix A

iii

Table A-1 Error Recovery Procedures

ERP

Number

Procedure Detail

C Cycle power to the drive using the AC switch on

the front panel of the module. Wait 30 seconds to

power on again.

D Turn off power to the module and inspect

connectors and cables.

F Invalid operation. Select parameters correctly and

try again

G Call Technical Support.

A.1.3.2 Fault Symptom Codes (FSC)

Fault Symptom Codes appear in the Fault Screen described

in Section A.1 of the Appendix. Each FSC is accompanied

by a descriptive message and instructions for clearing the

fault. If a fault persists, look up the FSC in Table A-1 and

call the Technical Support Representative. Be sure to

furnish the FSC to help identify the problem.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 180 181

Pas de commentaire

Hp NonStop G-Series Manuel d'utilisateur Page 156