Hp NonStop G-Series Manuel d'utilisateur télécharger pdf (Page 56)

5157/5157 ACL S-Series Subsystems Installation/ Users Guide

Configuring and Operating the 5157 Tape Drive

4-3

2. After calibration completes, Tape in Use remains lit.

3. The indicator shows the tape’s prerecorded density, such as 2.6

GB or 6.0 GB.

4. The drive’s control panel can be used at various times, not just

after loading a tape. Density selection is inactive until the Write

from BOT command is issued. The controller remembers the

density selection state until one of the following occurs:

• Change the density selection

• Unload the tape

4.2.2.1 Density Select Example

If a tape with a prerecorded 2.6 GB density is used, and the

Density Select button is used to select 10.0 GB density, the

following will happen:

• The 2.6 indicator remains lit (density has not changed yet), and

the steady light indicates recorded tape density

• The 10.0 indicator blinks (density change is pending)

• Density Override indicator lights

When a Write from BOT occurs, the following will happen:

• The 2.6 indicator turns off

• 10.0 indicator lights steadily

• Density Override remains lit

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 180 181

Pas de commentaire

Hp NonStop G-Series Manuel d'utilisateur Page 56