Hp ProLiant MicroServer Gen8 Manuel d'utilisateur télécharger pdf (Page 31)

Setup 31

• Health LED bar—Solid blue

For server management tasks after the initial server setup, use either the dedicated iLO connector

(enabled by default) or the NIC 1/shared iLO connector (It is disabled by default. Enable the shared

iLO function in iLO RBSU).

For more information on iLO management tasks, see the HP website

(http://www.hp.com/go/ilomgmtengine/docs).

Registering the server

To experience quicker service and more efficient support, register the product at the HP Product Registration

website (http://register.hp.com).

Setting up the HP PS1810-8G Switch (optional)

If you intend to use the server with the companion HP PS1810-8G Switch, follow the procedures in this

section. For deployments requiring more than eight network ports, HP recommends using the HP

PS1810-24G Switch instead of the HP PS1810-8G Switch.

For more information on switch-related settings and operational procedures, see the documentation for your

switch model on the HP website (http://www.hp.com/networking/support).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 94 95

Pas de commentaire

Hp ProLiant MicroServer Gen8 Manuel d'utilisateur Page 31