Hp ProLiant MicroServer Gen8 Manuel d'utilisateur télécharger pdf (Page 48)

Hardware options installation 48

For cable routing information, see "Optical drive cabling (on page 59)."

8. Secure the optical drive SATA cable in the designated cable management clips:

a. Secure the excess cable in the top chassis cable clip.

b. Secure the cable in the internal left side chassis cable clip.

9. Install the chassis cover (on page 19).

10. Connect the power cord to the server.

11. Press the Power On/Standby button.

The server exits standby mode and applies full power to the system. The system power LED changes

from amber to green.

Memory options

The server memory subsystem supports UDIMMs only. UDIMMs represent the most basic type of memory

module and offer lower latency and (relatively) low power consumption, but are limited in capacity.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 94 95

Pas de commentaire

Hp ProLiant MicroServer Gen8 Manuel d'utilisateur Page 48