Hp ProLiant MicroServer Gen8 Manuel d'utilisateur télécharger pdf (Page 37)

Setup 37

6. Connect an Ethernet cable to the server NIC 1/shared iLO connector, and then connect the cable to any

switch network port.

Complete the switch setup

After the Ethernet cable connection is made, check the network LED status on both the server and the switch

to confirm successful connection:

• In the server front panel, the NIC status LED —Solid green

• In the switch, the Link/Act LED on the network connector used—Initially, solid green to indicate

successful connection, and then flashing green to indicate active communication with the network.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 94 95

HP ProLiant MicroServer Gen8 1
User Guide 1
Contents 3
Contents 4 4
Contents 5 5
Component identification 6
Front panel LEDs and buttons 7
Rear panel components 8
Rear panel LEDs and buttons 9
System board components 9
Item Description 10
DIMM slot locations 11
System maintenance switch 11
Drive numbering 12
FBWC module LED definitions 13
Fan location 14
T-10/T-15 Torx screwdriver 14
Operations 15
Open the front bezel 16
Remove the front bezel 17
Install the front bezel 18
Remove the chassis cover 19
Install the chassis cover 19
Operations 21 21
Operations 22 22
Optimum environment 23
Temperature requirements 24
Power requirements 24
Server warnings and cautions 25
Installing hardware options 25
Setup 26 26
• Dedicated iLO connector 27
Configure the drive 30
Install the operating system 30
Complete the system setup 30
Registering the server 31
Setup 32 32
Complete the switch setup 37
Introduction 38
Bezel faceplate 38
Drive options 40
Controller options 42
Optical drive option 46
Memory options 48
HP SmartMemory 49
DIMM identification 49
ECC memory 50
Installing a DIMM 51
Expansion board options 52
Cabling 57
Capacitor pack cabling 58
Optical drive cabling 59
Front I/O assembly cabling 59
System fan cabling 60
Power supply cabling 61
Server mode 62
Product QuickSpecs 62
HP iLO Management 62
Active Health System 63
Intelligent Provisioning 64
HP Insight Diagnostics 65
Erase Utility 65
HP Service Pack for ProLiant 67
HP ROM-Based Setup Utility 67
Boot options 68
Utilities and features 69
Keeping the system current 70
Software and firmware 71
Version control 71
ProLiant servers 71
Troubleshooting 73
System battery replacement 74
Regulatory information 75
Warranty information 76
Electrostatic discharge 77
Specifications 78
Specification Value 79
Support and other resources 80
Customer Self Repair 82
Reparo feito pelo cliente 84
Acronyms and abbreviations 88
Virtual Connect 91
Version Control Agent 91
Documentation feedback 92
Index 93 93
Index 94 94
Index 95 95

Commentaires sur ces manuels

Pas de commentaire

Hp ProLiant MicroServer Gen8 Manuel d'utilisateur Page 37

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Hp ProLiant MicroServer Gen8