HP Data Center Environmental Edge Manuel d'installation télécharger pdf (Page 37)

(Optional) Sensor Base Stations 37

If a support bracket is available, use cable ties to secure the housing box to the support bracket.

2. Route the ultrasonic probe to the appropriate locations along the chilled water pipe.

3. Connect the housing box to the required sources.

Callout Component Description

Supply temperature Routed to the supply side of the chilled water pipe to measure temperature

Power connector Connected to AC power

Return temperature Routed to the return side of the chilled water pipe to measure temperature

Downstream flow meter Routed to the downstream of the chilled water pipe to measure flow rate

Upstream flow meter Routed to the upstream of the chilled water pipe to measure flow rate

4. After all hardware is installed, power up the components ("Power up procedure" on page 70).

Installation is complete.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 81 82

Pas de commentaire

HP Data Center Environmental Edge Manuel d'installation Page 37