HP Data Center Environmental Edge Manuel d'installation télécharger pdf (Page 39)

(Optional) Sensor Base Stations 39

Connect a USB connector from the PC to the USB configuration port on the inside of the Chilled Water

Base Station. The PC must have the Dynasonic ULTRALINK

™

software installed.

2. Open the ULTRALINK

™

program.

3. When the program prompts you for a COM Port, enter the appropriate Windows®-assigned USB

COM Port. To locate your COM Port, see the Device Manager screen in your Windows® operating

system.

4. On the bottom, right-hand side of the home run mode screen, verify that the USB connector is

communicating with the Chilled Water Base Station. A green OK indicates communication between the

base station and the PC.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 81 82

Pas de commentaire

HP Data Center Environmental Edge Manuel d'installation Page 39