HP Web Jetadmin Software Manuel d'utilisateur télécharger pdf (Page 413)

Fax Send - Other Options or Other Settings

This option lets you dene what the device should do if the number dialed is busy or there is no answer.

Fax Send - Resolution

This option lets you sets the default resolution that will be used when sending faxes. The available selections are

Standard, Fine, Superne, and Photo. This lets you control the quality of the sent faxes when the default setting

is used.

To congure this option, select the desired resolution.

Fax Send - Setup

Use this option to specify the send settings for faxes. You can specify the modem and ringer volumes, the dial

and redial settings, and whether the fax device should use JBIG compression or Error Correction Mode (ECM).

Use the following steps to congure this option:

1. Select the fax dial volume from the Fax dial volume drop-down list.

2. To enable Error Correction Mode (ECM), select Enabled from the Error correction mode drop-down list. ECM

should normally be enabled, except in extreme circumstances where line conditions are too poor to

support ECM faxes.

3. To enable JBIG compression, select Enabled from the JBIG compression drop-down list. JBIG compression is

a protocol that allows for faster fax sending between two JBIG compliant fax devices. It is possible that

older fax machines may fail to connect when JBIG is enabled. For such a scenario, use the JBIG disable

option.

4. Select Tone or Pulse from the Dialing mode drop-down list.

5. Select the number of retry attempts when the receiving line is busy, from the Redial on busy drop-down

list.

6. Select the number of retry attempts when the receiving line fails to answer from the Redial on no answer

drop-down list.

7. To have the fax wait for a dial tone before dialing for an outbound fax document, select Enabled from the

Detect dial tone drop-down list.

8. To specify a dialing prex, type the value in the Dialing prex text box.

9. To print the billing code report, select the Print billing code list checkbox.

Fax Send Settings

Use this option to specify the settings for sending faxes. You can specify the fax send method, scan settings,

notication settings, internal modem settings, LAN fax settings, and Internet fax settings.

Use the following steps to congure this option:

1. To enable sending faxes, select the Enable fax send checkbox.

2. Select the method the device uses to send faxes from the Fax send method drop-down list.

ENWW Device Conguration Options for Fax 387

1 2 ... 408 409 410 411 412 413 414 415 416 417 418 ... 491 492

Pas de commentaire

HP Web Jetadmin Software Manuel d'utilisateur Page 413