HP Web Jetadmin Software Manuel d'utilisateur télécharger pdf (Page 415)

NOTE: To prevent the device from reporting a jam when a user scans an original document that has

multiple pages, such as a folded booklet, make sure that the Misfeed detection checkbox is not

selected. The device does not report a misfeed when multiple pages are fed at one time.

●

Job build: Select this checkbox to allow users to combine multiple scanned pages into a single

outgoing fax. If this checkbox is not selected, multiple scanned pages result in multiple outgoing

faxes.

●

Enable Blank Page Suppression: Select this checkbox to remove blank pages from the outgoing faxes.

4. In the Common Job Settings—Notication settings section, specify the following settings for fax

notication reports:

●

Condition on which to notify: Select when the device generates notication reports for sent faxes.

●

Include thumbnail: Select this checkbox to include a thumbnail image of each fax with the fax

notication report.

●

Method used to deliver notication: Select how the device delivers fax notication reports.

●

Email address: Enter the email address to which the notication reports are sent.

5. In the Common Job Settings—General Fax Send Settings section, select the Fax number conrmation

checkbox to display a conrmation screen asking the user to enter the fax number again. This option is

useful for companies that send restricted and condential information via fax.

6. In the Internal modem—General fax settings section, specify the following settings for the internal modem

on the device:

●

Enable PC fax send: Select this checkbox to allow users to send faxes from their computers.

●

Enable error correction mode: Select this checkbox to enable Error Correction Mode (ECM). If ECM is

enabled, the receiving fax device checks the fax information for errors. If the receiving fax device

detects an error, it requests the sending fax device to resend all or part of the fax.

NOTE: ECM is normally enabled. However, if the line conditions are too poor to support ECM faxes,

do not select the Enable error correction mode checkbox.

●

Enable JBIG compression: Select this checkbox to enable JBIG compression. JBIG compression is a

protocol that allows for faster fax transmissions between two JBIG-compliant fax devices.

NOTE: Older fax machines might fail to connect if JBIG compression is enabled.

●

Enable overlay header: Select this checkbox to overlay or prepend the fax header to the fax pages.

●

Enable speed dialing matching: Select this checkbox to enable speed dial matching. When speed dial

matching is enabled, walk-up users can enter speed dial numbers instead of full fax phone numbers

when sending a fax.

7. In the Internal modem—Fax dialing settings section, specify the following settings for the internal modem

on the device:

●

Fax dial volume: Select the volume of the internal modem dialer.

●

Dialing mode: Select the dialing mode used.

●

Dialing prex: Enter the dialing prex added to all phone numbers when dialed. For example, enter 9

if it is required to access an outside line.

●

Fax send speed: Select the speed used to process outgoing faxes.

●

Redial interval: Enter the number of minutes that the internal modem waits between redialing

attempts.

ENWW Device Conguration Options for Fax 389

1 2 ... 410 411 412 413 414 415 416 417 418 419 420 ... 491 492

Commentaires sur ces manuels

Pas de commentaire

HP Web Jetadmin Software Manuel d'utilisateur Page 415

Commentaires sur ces manuels

Produits connexes et manuels pour Multifonctionnels HP Web Jetadmin Software