HP Embedded Firewall Series Manuel d'utilisateur télécharger pdf (Page 22)

7 Novell NetWare Driver Installation

Installation with Novell Already Installed

Be sure that the server has the latest support pack available installed. The latest support

pack can be found at: http://support.novell.com/misc/patlst.htm

1 Insert the NIC into a PCI slot.

2 Go to system console on the server.

3 Run nwconfig.

4 Go to driver options, configure network drivers.

5 Choose Select a driver.

a Press Enter if the drivers are contained on a floppy disk, or

b Press F3 and enter the path of the drivers if they are not contained on a floppy disk.

6 Select Yes to copy the driver.

7 Enter the slot number of the NIC.

For instructions on identifying the slot number, see the next section, “Identifying the

Slot Number.”

8 Configure the protocols as necessary.

9 Press F10 to save the parameters.

10 Select Save parameters and load driver.

After the driver is loaded, you may continue to load other drivers if needed.

Identifying the Slot Number

If you do not know the slot number of the NIC you are installing, follow the instructions

below to identify the slot number.

1 Press the Ctrl and Esc keys on your keyboard.

2 Go to system console.

3 At the system console, type Load 3C99X .

This loads the driver.

4 At the system console, type config .

5 Look for the driver name of the 3Com NIC.

6 Note the slot number used by the NIC.

7 Typ e Unload 3C99X at the system console.

8 Press the Ctrl and Esc keys on your keyboard.

9 Go to nwconfig .

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 85 86

Pas de commentaire

HP Embedded Firewall Series Manuel d'utilisateur Page 22