Hp Integrity NonStop J-Series Manuel d'utilisateur télécharger pdf (Page 233)

Data Collection Services

Indicates whether automatic data collection for failed system resources is

enabled or disabled. To change this attribute state, use the Enable/Disable

Automation of Data Collection action.

Automatic Data Collection State

Indicates the volume in which automatic or manual data collection will take

place. This volume is assigned by using the Set Data Collection Volume

action.

Diagnostic Data Collection Volume

Indicates the number of days that collected hardware failure data (collected

either automatically or by the Collect Diagnostic Dataaction) is retained on

the system before being deleted.

Days to Persist Collected Diagnostic Data

System Load Configuration

Displays the name of an alternate system load configuration, as specified

through the Save As System Load Configuration action (located under the

Disk, FC Disk, and CLIM-Attached Disk objects in the OSM Service

Connection). You can specify up to four such alternate system disks; each

one is displayed in the system attributes (under a separate System Load

Configuration heading), and can be selected from the Configuration menu

of the System Load dialog box in the OSM Low-Level Link.

These configurations can be deleted by the system-level Delete System Load

Configuration action.

NOTE: With OSM Low-Level Link T0633 AAQ and later, you can also save

system configuration files on the system console. Those saved configurations

are not displayed as attributes values in the OSM Service Connection, but

can be used during the system load operations in the Low-Level Link. For

more information, see the OSM Low-Level Link online help.

Configuration Name

The name of this alternate system disk, as configured in SCF.Disk Name

Incident Report Configuration

Indicates whether or not OSM's ability to create Problem Incident Reports

has been suppressed. This suppression is accomplished by the Suppress

Problem Incident Report Creation action and is desirable to stop dial-out of

known problems, such as those that may occur during CRU replacements.

Values: Suppressed, Unsuppressed

Problem Incident Report Creation State

Actions

Add Node to ServerNet Cluster

Launches a guided procedure that adds the local system to a ServerNet Cluster or BladeCluster.

This procedure is also used to configure or display information for Expand-over-ServerNet line

handlers.

NOTE: This action is not applicable for Integrity NonStop NS1000, NS1200, NS2000 series,

NS2100, NS2200 series, NS2300, NS2400 series, NS5000, or NS3000AC servers.

Bring Up and Balance Storage Paths

Launches a guided procedure to help recover from ServerNet disruption to storage paths.

Check DHCP and DNS Server Status

Invokes checks to determine whether DHCP, DNS, and TFTPD servers are running.

System 233

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 327 328

Commentaires sur ces manuels

Pas de commentaire

Hp Integrity NonStop J-Series Manuel d'utilisateur Page 233

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Hp Integrity NonStop J-Series