HP Jetdirect 620n Fast Ethernet Print Server Manuel d'installation télécharger pdf (Page 23)

Troubleshooting Tools 23

ENWW

Note The HP Jetdirect 10/100Base-TX print server may

require up to 10 seconds to establish a connection

on the network.

Try the following troubleshooting procedures:

O Verify cabling connections.

O Configure the print server’s 10/100TX link setting directly (for

example, using the EIO menu on the printer’s control panel).

Verify that the configuration of the connecting network device

(such as a network switch) matches. For example, if you set the

print server for 100Base-TX Full-Duplex operation, the port on

the network switch must also be set to 100Base-TX Full-Duplex

operation. Power-cycle the printer to reinitialize the setting.

O On the Jetdirect Configuration Page, compare your configuration

for the following parameters:

Parameter Expected Messages for 10/100TX Cards

PORT SELECT: RJ-45

PORT CONFIG: 100TX HALF, 100TX FULL, 10BASE-T HALF,

10BASE-T FULL

AUTONEGOTIATION: ON (Autonegotiation is enabled), or

OFF (Autonegotiation is disabled, 10/100TX

configuration has been manually set)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Pas de commentaire

HP Jetdirect 620n Fast Ethernet Print Server Manuel d'installation Page 23