HP E5000 Guide de l'utilisateur télécharger pdf (Page 110)

8. Remove the enclosure from the rack.

WARNING! The messaging system enclosure is heavy, even after removing the hard drives.

Always use at least two people to remove the messaging system from the rack.

9. Remove all eight screws from the front bezel and pull the handle down 90 degrees (1). Then

lift the front bezel up and out to remove the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Replacing the front bezel (full)

To replace the front bezel:

1. Install the replacement front bezel with the handle at a 90 degree angle, making sure the

bottom pins are aligned with the bottom holes (1), and replace the screws in the front bezel

(2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

2. Close the drive handle.

3. Push the drive drawer back into the messaging system enclosure.

110 Removing and replacing hardware components

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 206 207

Pas de commentaire

HP E5000 Guide de l'utilisateur Page 110