HP E5000 Guide de l'utilisateur télécharger pdf (Page 146)

1. Connect the replacement capacitor pack to the cache module.

2. Install the cache module in the cache module slot.

3. Install cache module on the controller, and then close the ejector latches on the cache module

slot.

4. Install the capacitor pack bracket and insert the replacement capacitor pack on the chassis

wall.

5. Install the access panel.

6. Install the server blade in the enclosure.

IMPORTANT: After installing a capacitor pack, you might see a POST message during reboot

indicating that the array accelerator (cache) is disabled temporarily. This behavior is normal

because the new capacitor pack is likely to have a low charge.

The controller operates properly while the capacitor pack is recharging, although the performance

advantage of the array accelerator is absent. You do not need to take any action because the

recharge process begins automatically when you install the capacitor pack. When the capacitor

pack has been charged to a predetermined level, the array accelerator is enabled automatically.

146 Removing and replacing hardware components

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 206 207

Pas de commentaire

HP E5000 Guide de l'utilisateur Page 146