HP Netserver 5971-0821 Manuel d'utilisateur télécharger pdf (Page 30)

8. Press Enter to continue with the Windows NT operating system setup. Fol-

low the instructions on-screen and in the Windows NT documentation to

complete the installation.

Completing a Fresh Windows NT 4.0 Installation From CD-ROM

1. Insert the Windows NT 4.0 CD into the CD-ROM drive.

2. Start your system. Press the F6 key when you see the following message:

“Setup is inspecting your computer’s hardware configuration...”

3. If you do not see this message, your system may not be setup to boot from a

CD-ROM. You will need to install from floppy disks. See “Completing a

Fresh Windows NT 4.0 Installation From Floppy Disk” on page 23.

4. When prompted, press S to specify an additional device.

5. Press Enter to select Others; insert the HP Ultra3 Family Manager Set disk

for Windows NT into your floppy disk drive.

6. Using the arrow keys, select the following driver and press Enter:

Adaptec Ultra3 PCI SCSI Controller (NT4.0)

7. To add other host adapters, press S and repeat from Step 4 for each addi-

tional adapter and insert the appropriate driver disk.

8. Press Enter to continue with the Windows NT operating system setup. Fol-

low the instructions on-screen and in the Windows NT documentation to

complete the installation.

Installing the Driver When Windows NT is

Already Installed

To update or install the adpu160m.sys driver if Windows NT 4.0 is already

installed, follow the instructions below.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 119 120

Pas de commentaire

HP Netserver 5971-0821 Manuel d'utilisateur Page 30