HP Netserver 5971-0821 Manuel d'utilisateur télécharger pdf (Page 51)

[xxxxx012] Error issuing command

[xxxxxx99] Error issuing command

The driver does not recognize the target device.

[xxxxx021] Target device protocol error

An unexpected event occurred during data transfer between the adapter and tar-

get device. Normally, this indicates a faulty or non-compliant target device.

[xxxxx022] Adapter or target device protocol error

The adapter or target device has broken the communication protocol. A badly

behaving device could cause this message to appear. Normally this is not a seri-

ous problem. If you get this message frequently over a short period of time, it

could indicate that the device or system is malfunctioning. Unplug or power

down unused devices to see if the problem persists.

[xxxxx023] Target device parity error

The driver has detected a parity error by the target device.

[xxxxx024] Data overrun or underrun

The adapter was given more or less data than the expected amount of data.

[xxxxx031] Target device queue full

The target device internal buffer is full.

[xxxxx032] Target device busy

The target device reports a Busy status. Another program may already be using

this device.

[xxxxx050] Host adapter failure

[xxxxxx9A] Host adapter failure

Your host adapter may not be properly installed or is defective. Try resetting the

adapter in the PCI slot, or try installing it a different PCI slot.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 119 120

Pas de commentaire

HP Netserver 5971-0821 Manuel d'utilisateur Page 51