HP Netserver 5971-0821 Manuel d'utilisateur télécharger pdf (Page 34)

• /INSTRUMENTATION—enables recording of I/O statistics and errors.

If this option is not specified, instrumentation defaults to disabled. The

data type for this value is REG_SZ.

• /INSTR_ERRLOG_Z=nnn—sets the maximum number of error log

entries, if /INSTRUMENTATION is enabled. If a number is not

specified, the maximum number or error log entries defaults to 32. Valid

values are 0-128. The data type for this value is REG_SZ.

• /MAXTAGS=nnn—specifies the tagged command queue depth. If a

number is not specified, the tagged queue depth defaults to 128. Valid

values are 1-255. The data type for this value is REG_SZ.

• /HOTPLUG —enables Hot-Plug PCI feature. If this option is not

specified, Hot-Plug PCI feature defaults to disabled.

To enter driver-specific parameters, follow these steps:

1. Select Run from the Start button.

2. Type regedt32 and press Enter.

3. Open the registry list to the following location:

\HKEY_LOCAL_MACHINE\System\CurrentControlSet\

Services\adpu160m\Parameters\Device\DriverParameters

If the Parameters, Device, and Driver Parameters keys already exist, skip to

Step 10 below to begin entering parameters. If the keys do not yet exist, you

will need to create them by continuing with Step 4.

4. Clickontheadpu160m key.

5. Select Add Key from the Edit menu; Type Parameters in the Key Name

edit box. Leave the Class edit box blank.

6. ClickontheParameters key.

7. Select Add Key from the Edit menu; Type Device in the Key Name edit

box. Leave the Class edit box blank.

To specify a certain host adapter, append Device with the number of the host

adapter. For example, type Device0 for the first host adapter, Device1 for the

second, etc. If you omit the host adapter number, the configuration information

applies to all Ultra3 host adapters.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 119 120

Pas de commentaire

HP Netserver 5971-0821 Manuel d'utilisateur Page 34