HP Netserver 5971-0821 Manuel d'utilisateur télécharger pdf (Page 78)

d Modify the mscsi file according to your hardware setup:

• If you are booting from an Ultra3 SCSI host bus adapter, make sure the

host adapter prefix for the host adapter number 0 is ad160.

• If you are not booting from an Ultra3 SCSI host bus adapter, make sure

the host adapter prefix for the host adapter number 0 is the appropriate

prefix for each device on your primary HP host adapter. See the table

above.

e Save the file and exit the text editor.

4 Rebuild the UNIX kernel by following these steps:

a Type the following at the # prompt and press Enter after each line:

cd /etc/conf/cf.d

./Iink_unix

Status messages appear on-screen.

b When the kernel has been built, shut down the system by typing shutdown-

g0 and pressing Enter.

c Turn OFF the system power when you are prompted to do so.

If you need to reconfigure your system, you may do so now.

d Add or remove host adapters or devices as needed.

5 Boot the new kernel by following these steps:

a Follow the on-screen instructions to reboot your system, usually by pressing

Enter.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 119 120

Pas de commentaire

HP Netserver 5971-0821 Manuel d'utilisateur Page 78