Hp D2D100 Backup System Manuel d'utilisateur télécharger pdf (Page 118)

Figure 43 Removing the d isk cover

8. The diagram on the lid of the HP D2D Backup System shows how the disks are cabled.

a. Check that the disk identiﬁed as failed in the Web Management interface is plugged into the

corresponding SATA port. For example, if Disk 1 is shown as failed, trace the cable to the SATA

port.ItshouldbeinSATAPort1.(Ifitisnot,youmayneedtoremoveseveraldiskstolocatethe

failed on

e, identiﬁedbytheuniqueserialnumber.)

b. Remove the disk from the disk bay and check the serial number. It must match the serial number

in the Web Management interface.

c. If the ser

ial number is correct, it is safe to remove and replace the disk. If the serial number is

not correct, you must locate the correct disk by checking all the others.

CAUTION:

If you replace the wrong disk, you could lose all your data.

Power

Supply

System Board

HDD 4

HDD 3

HDD 2

HDD 1

SATA4

SATA3

SATA2

SATA1

Figure 44 Identifying the hard disk

9. Observing normal anti-static precautions, remove the failed disk.

Disconnectthepoweranddatacablesfromthebackoftheinstalleddrive(1). Adrivelatch(2)

with release tabs secures the hard drives in the d rive bay. Lift the release tab o n the drive latch.

Slide the hard disk drive from the drive bay (3).

118

Hard disk replacement

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 124 125 126

Pas de commentaire

Hp D2D100 Backup System Manuel d'utilisateur Page 118