Hp D2D100 Backup System Manuel d'utilisateur télécharger pdf (Page 36)

Figure 22 Replac ing the bezel

3. Use t wo hands to place the access panel ﬂat against the chassis (1), the back of the access panel

extending about 2.5 cm (1.0 in) behind the back of the server. Make sure the hook s on the access

panel align with the holes on the edges of the chassis. Slide (2) the access panel toward the front of

the chassis to position it into place. Tighten the captive thumbscrew (3) to secure the access pa nel.

Figure 23 Replacing the access panel

4. Reconnect the network cable and the power cord.

Connec

ting an external tape drive

Read th

is section if your are connecting an external tape drive.

NOTE:

You can only connect an external tape drive, if you have already installed a recommended HBA.

1. Connect the device c able (SCSI or SAS) to the appropriate por ts on the HBA and tape drive. The

example shows a SCSI tape d rive.

2. Plug the power cable (1)ecurely into the socket on the rear panel of the drive and plug the other end

ofthepowercableintothepoweroutlet. Thepoweron/offswitch(2)is on the front panel.

Attaching a physical tape drive (optional)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 125 126

Pas de commentaire

Hp D2D100 Backup System Manuel d'utilisateur Page 36