Hp D2D100 Backup System Manuel d'utilisateur télécharger pdf (Page 73)

Table 5 Network parameters

Network Name:

This is the name of the HP D2 D Backup System. You can use the network name,

instead of the IP address, to log on to the Web Management Interface.

DHCP:

Check or uncheck the box to enable or disable this feature. If DHCP is turned off,

you must manually specify all the network settings for the HP D2D Backup System. If

DHCP is turned on, the majority of the network settings are obtained automatically.

However, even when DHCP is on the Network Name must be speciﬁed. Other

parameters, such as Domain Name and DNS Server Address, become optional.

You can override the automatic settings and enter your own values, if required,

but this is not usually necessary.

IP Address:

This is the IP address for the device. The H P D2D Backup System supports both

dynamic (DHCP) and static IP addressing. The IP Address must be unique on the

network. If you are using static IP addressing, you must also provide the subnet

mask, default gateway and, optionally, domain name.

Subnet M ask:

This deter

mines the subnet to which the IP address belongs. (Static IP addressing

only.)

Gateway:

This is the node that connects the HP D2D Backup System to the network that is

servicing the web pages. (Static IP addressing only.)

Domain:

This is the group of devices on the network to which the HP D2D Backup System

belongs. (Static IP addressing only.)

DNS Server Name

1/2/3:

These are

the DNS IP addresses. When using DHCP these may be obtained

automat

ically. Ask your network administrator to advise what you should enter.

Re setting network settings to factory defaults

There are some conditions in which a previously conﬁgured device m ay fail to be discovered on a

network and, therefore, may be unreachable if the network parameters are invalid for the network to

which the device is attached. In this case, it may be necessary to reset the net working parameters

and device name to factory defaults.

To reset the network settings:

1. Ensure that there are no backup or restore jobs in progress to the device.

2. Press the Power On button on the front of the HP D2D B ackup System three times in quick succession

to reset it.

After approximately 5 seconds, the HP D2D Backup System will beg in its reboot sequence.

NOTE:

The HP D2D Backup System will be reset to factory networking settings and the Administrator password

will be reset to Admin. No user data will be lost.

3. After the reboot, the device will be in D HCP mode and also available for discovery using the

Installation wizard provided on the StorageWorks CD.

Beacon mode

Beacon mode ﬂashes the LEDs on the HP D2D Backup System. It is useful if you have several HP D2D

Backup Systems on your network and want to conﬁrm which unit is being conﬁgured.

• Click Turn Beacon On to activate beacon mode.

• If you do not switch off Beacon Mode from the Network page, it will continue for 5 minutes.

D2D Backup System

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 125 126

Commentaires sur ces manuels

Pas de commentaire

Hp D2D100 Backup System Manuel d'utilisateur Page 73

Commentaires sur ces manuels

Produits connexes et manuels pour Stockage Hp D2D100 Backup System