Hp D2D100 Backup System Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 126
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
1 B efore you s tart
In this chapter:
Overview on page 15
Optional tape at tach one on page 15
Software a nd hardware requirements on page 16
Terminology on page 16
Storage capacity on page 19
Compression on page 21
Overview
The HP StorageWorks D2D B a ckup System is an iSCSI disk-based storage appliance that emulates up to
six tape devices; these tape devices can be used to back up a maximum of six host net work servers or
PCs. Each ta
pe device is congured as an 1x8 G2 Ultrium Tape Autoloader (or standalone Ultrium Tape
Drive). Au
toloaders may be congured with between 8 and 24 slots.
1. LEDs
4. Network connector
2. Pow
er On button
5. P ow
er connector
3. Location for optional attached tape drive (see Attaching a p hysical tape drive”onpage29)
Figure 1 Front and rear view of the HP D2D Bac kup System
Optional tape attach
An Ultrium Tape Drive may be at tached directly to the HP D2D Backup System, allowing the user to store
backups offsite. An internal tape d rive must be half-height and is installed in the half-height bay above
the LEDs, labeled 3 on Figure 1. External tape drives may be half-height or full-height. Both SAS and
SCSI tape drives are supported and require installation of a host bus adapter (HBA).
D2D Backup System
15
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 125 126

Commentaires sur ces manuels

Pas de commentaire