Hp D2D100 Backup System Manuel d'utilisateur télécharger pdf (Page 31)

Figure 12 Removing th e front bezel

Installing the HBA

CAUTION:

Static electricity can damage electronic components. Always wear an antistatic wriststrap if one is

available. If not, after you have disconnected power from the server and removed the cover, touch a bare

metal part of the chassis. Similarly, touch a bare metal part of the drive before installing it.

The s upported PCI-Express HBA should be installed in the top PCI slot. Please refer to

ww.hp.com/go/connect for a list of all supported host bus adapters and tape drives. No additional

drivers are required for recommended HBAs and tape drives; they are included in the H P D2D Backup

System ﬁrmware.

1. Undo the retaining screw (1) and remove the slot cover retainer (2).

Figure 13 Removing t he slot cover retainer

2. Remove the cover from the top expansion slot.

D2D Backup System

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 125 126

Pas de commentaire

Hp D2D100 Backup System Manuel d'utilisateur Page 31