
Option Description
NOTE: The option /noreboot can be used in conjunction with this option.
Installing RGS Receiver (Linux)
To install RGS Receiver on Linux®:
1. Log in as root.
2. Go to the directory where you downloaded RGS.
3. Execute the following command:
./install.sh
TIP: Optionally, add the directory /opt/hpremote/rgreceiver to your PATH environment
variable.
Installing RGS Sender (Linux)
To install RGS Sender on Linux:
IMPORTANT: Before proceeding, make sure you already have the appropriate NVIDIA® graphics driver
installed on the sender. The NVIDIA driver installation creates the le /etc/X11/xorg.conf, which might
be used during the installation process (depending on your Linux distribution), so the NVIDIA driver must be
installed rst. System requirements can be found in the QuickSpecs (see Finding more information on page 4).
1. Log in as root.
2. Go to the directory where you downloaded RGS, and change to the directory lin64/sender.
3. Execute the following command:
./install.sh
4. The installer gives you the option to allow some conguration les to be modied automatically. You
must accept this option to complete the installation.
5. If the sender has the pcsc-lite package installed, the installer gives you the option to install smart card
redirection. By default, this feature does not install.
Installing RGS Receiver (Mac OS)
On Mac OS, you can install RGS Receiver using the installer wizard or on the command line.
NOTE: If the software is already installed, the installation process overwrites it.
Installer wizard installation
1. Log in as an administrator (or be able to provide administrator credentials).
2. Run HP RGS Receiver.pkg, and then follow the on-screen instructions.
Command-line installation
Execute the following command:
Installing RGS Receiver (Linux) 11
Commentaires sur ces manuels