HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 79)

3. Right-click the network adapter you want to congure, and then select Properties.

4. Click the Advanced tab.

5. In the list of properties, locate the property that controls the speed and duplex setting. The name can

vary, but it is usually something like Speed & Duplex or Link Speed & Duplex.

6. From the Value drop-down list, select the fastest speed your network can support, and be sure to select

the Full Duplex version of that speed.

To congure a network interface to force a particular network speed on Linux:

▲

As root, use a command like in the following example. This example sets network interface 0 as a 100

Mb/sec connection running full duplex mode:

$ /usr/local/sbin/ethtool -s eth0 speed 100 duplex full autoneg off

If you are not satised with your network performance, look at the log les on your network switch (if the

receiver is connected to one). A signicant number of errors on the switch port may indicate that the

computer or network is not congured correctly. Work with your IT organization to optimize your computer

and network conguration.

VPN with HP Velocity

If HP Velocity is used in combination with a VPN that is between the sender and the receiver, and if the VPN is

congured with a maximum transmission unit (MTU) value less than the default MTU value of RGS (1500),

network packets might be fragmented, and performance might degrade.

You can change the MTU value of RGS to better control the packet size. To do this, you must modify a property

in two les named cong. One is in the RGS Sender installation directory, and the other is in the RGS Receiver

installation directory. In each le, edit the following property:

IceLive.livessl.liveUDP.mtu=1500

Make the value setting lower than the MTU value of the VPN, and use the same value for both les. HP

recommends a value of 1396.

VPN with HP Velocity 69

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 100 101

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 79