HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 53

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 101
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 52
Rgsender.Audio.Linux.DeviceName=plughw:1,0
Remote Clipboard
Remote Clipboard allows you to cut, copy, and paste data between the receiver and the sender or between
two dierent senders.
Cutting and pasting text is supported on Windows, Linux, and Mac OS. Cutting and pasting an image is only
supported between a Windows-based sender and Windows-based receiver.
On Windows, Remote Clipboard must be enabled during both the RGS Sender and RGS Receiver installations
(see
Installation on page 6).
On Linux, Remote Clipboard is installed by default.
On Windows, Linux, and Mac OS, Remote Clipboard must also be enabled in RGS Receiver (see Connection
on page 19).
TIP: Setting the logging level of RGS Receiver or RGS Sender to DEBUG enables Remote Clipboard log
information.
Remote USB (Windows/ThinPro only)
Remote USB allows a receiver’s physically-attached USB devices to be virtually attached (mounted) to the
sender. This gives the sender direct access to the USB devices, as if the devices were physically attached to it.
See the following list for information about Remote USB support:
The sender must be Windows-based.
The receiver can be either Windows-based or ThinPro-based.
A receiver’s physically-attached USB devices can be collectively attached to a single sender. The devices
cannot be split between multiple senders, nor can they be collectively attached to multiple senders.
RGS supports all four USB data transfer types (bulk, isochronous, interrupt, and control).
USB devices that adhere to the USB 1.x or 2.x standard should work. However, webcams and devices that
are sensitive to timing might experience decreased performance, or they might not function at all. HP
recommends thoroughly testing any USB device intended for use with RGS.
USB 1.x and USB 2.x devices are supported on USB 3.x ports, but USB 3.x devices are not supported.
File copies might take longer due to the additional overhead of the network protocol on top of the USB
protocol.
Conguring the remoting behavior of individual USB devices (Windows only)
The remoting behavior for individual USB devices can be altered from what was set globally during
installation.
IMPORTANT: This conguration requires modications to the Windows registry. Registry modications
should be made with extreme caution, and you should always make a backup of the registry prior to making
any changes.
To congure the remoting behavior of a USB device:
Remote Clipboard 43
Vue de la page 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 100 101

Commentaires sur ces manuels

Pas de commentaire