HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 83)

The RGS Receiver window repeatedly dims and displays a connection warning message.

Cause Solution

There are frequent network disruptions between RGS Receiver

and RGS Sender.

If the notications are occurring too frequently, increase the RGS

Receiver warning timeout value.

The RGS Receiver window dims, and RGS Receiver disconnects and displays a connection error, but you can connect again

immediately.

Cause Solution

The length of the network disruption exceeded the error timeout

value of either RGS Receiver or RGS Sender.

NOTE: This could also occur if RGS Sender was stopped

unexpectedly.

Increase the error timeout value of RGS Receiver, RGS Sender, or

both.

When connecting to a Linux-based sender, the PAM authentication dialog on the receiver does not display long enough for

credentials to be entered.

Cause Solution

The RGS Receiver dialog timeout value is too low. Increase the dialog timeout value of RGS Receiver.

When connecting to the sender, the authorization dialog is not displayed long enough for the user to respond to it.

Cause Solution

The collaboration request timeout value of RGS Sender is too low. Increase the collaboration request timeout value of RGS Sender.

The RGS Receiver window is not updating.

Cause Solution

A network disruption occurred, but the warning and error timeout

values of RGS Receiver are set too high.

Decrease the warning and error timeout values of RGS Receiver.

Increasing the error timeout value of RGS Receiver does not appear to have an eect, and RGS Receiver still disconnects.

Cause Solution

The error timeout value of RGS Sender is less than that of RGS

Receiver.

Increase the error timeout value of RGS Sender so that its higher

than that of RGS Receiver.

Network timeouts 73

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 100 101

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 83