HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 57)

For a local account, using the example user1_computer\user1, the domain name used for Directory

Mode would be user1_computer.

The following example directory le species the senders for user1 and user2 in a local account environment:

user1_computer user1 RC_1 RC_2 RC_3

user2_computer user2 RC_4 RC_5 RC_6

For Linux-based senders, use UNIX as the domain name.

The domain name does not apply when using the directory le for Linux users. Instead, use the keyword

UNIX in place of the domain name. For example:

UNIX user1 RC_1 RC_2 RC_3

If the user name contains white-space characters, the name can be enclosed in double-quotes as shown

below:

domain1 "user1 user" RC_1 RC_2 RC_3

domain1 "user2 user" RC_4 RC_5 RC_6

Starting RGS Receiver in Directory Mode (Windows)

NOTE: Before attempting a connection in Directory Mode for the rst time, HP recommends that you rst

verify that RGS can connect to each computer individually.

▲

Windows 7: Select Start, select All Programs, select HP, select HP Remote Graphics Software, and then

select HP RGS Receiver Directory Mode.

Windows 8.1: Select the HP RGS Receiver Directory Mode tile on the Start screen.

Windows 10: Select Start , type RGS, and then select HP RGS Receiver Directory Mode from the search

results.

Alternately, RGS Receiver can be started in Directory Mode on the command line, using either of the following:

rgreceiver.exe -directory <file name>

rgreceiver.exe -directory

If a le name is specied after -directory, RGS Receiver uses that le as the directory le. If no le name

is specied, you are prompted to specify the path and name of the directory le.

In Directory Mode, RGS Receiver displays the name of the directory le. The Change button enables you to

specify a dierent directory le. The Connect All button is used to establish a connection to the senders listed

in the directory le.

After clicking Connect All, you’ll need to independently authenticate and log into each sender.

To bring a specic RGS Receiver window to the front:

1. Enable Setup Mode using the hotkey sequence (see Setup Mode (non-touch GUI only) on page 18).

2. Press Tab to open the RGS Receiver window selector, and then select the desired RGS Receiver window.

Starting RGS Receiver in Directory Mode (Mac OS)

▲

Run either of the following commands on the command line:

open -a "HP RGS Receiver" --args -directory Filename

Directory Mode (non-touch GUI only) 47

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 100 101

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 57