HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 25)

Starting an RGS session

To start an RGS session:

1. On the Home panel of RGS Receiver, enter the hostname or IP address of the sender, and then press the

Enter key or select the Connect button.

2. This step depends on the authentication method you are using (see Authentication on page 29).

Enter the credentials as required by the authentication method.

If authentication is successful, the RGS session starts, and the sender desktop appears inside the RGS

Receiver window that opens on the receiver.

Note the following additional information about creating an RGS connection:

●

If this is your rst time establishing an RGS connection, you might receive a conrmation message or

error message, depending on the activation status of RGS Advanced Features.

●

You cannot connect to more than one sender at a time using the GUI of RGS Receiver. If an attempt is

made to connect to a second sender, the connection to the rst sender is terminated. For information

about how to connect to more than one sender at a time, see Directory Mode (non-touch GUI only)

on page 46.

RGS Receiver window GUI (Windows/Linux)

NOTE: The RGS Receiver window might look slightly dierent in the touch GUI.

Item Description

1 The RGS Receiver toolbar provides easy access to the most frequently used options (see RGS Receiver toolbar GUI

(Windows/Linux) on page 16 for more information).

2 Scroll bars appear if the resolution of the sender is larger than the size of the RGS Receiver window.

Starting an RGS session 15

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 100 101

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 25