HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 44)

NVIDIA resolution-matching (Windows-based senders with NVIDIA graphics only)

NVIDIA resolution-matching provides the following additional features over the default resolution-matching

method:

●

Automatic loading and unloading of EDID les to allow a sender with fewer monitors than the receiver to

"fake" displays

NOTE: This is especially useful for virtual workstations where the hypervisor typically provides only

one display.

●

Rotated monitors on virtualized systems (specically, Citrix and VMware virtual machines)

●

Automatic application of custom resolutions on virtualized systems

NOTE: If NVIDIA resolution-matching fails to match the requested resolution/resolutions, RGS attempts the

default resolution-matching method.

To enable NVIDIA resolution-matching:

1. In rgsenderconfig, set

Rgsender.Compatibility.Displays.AllowNvidiaResolutionMatching to 1.

2. Restart the RGS Sender service.

– or –

Restart the sender.

NOTE: For more information about setting the property, see Setting property values in a conguration le

on page 63.

Creating and applying an EDID le

There are software tools available to create and edit an EDID le, but the easiest method is to use an existing

monitor from the receiver and temporarily attach it to the sender, which should be RGS Sender on Windows

with NVIDIA graphics. If you have several dierent displays that you use on the receiver, HP recommends that

you capture the EDID information of the one that has the highest display resolution. This will address all other

resolution needs.

To create and apply an EDID le:

1. Attach a monitor to the sender.

NOTE: This is not possible with blade workstations that use MXM graphics.

2. Open the NVIDIA Control Panel and click View system topology.

3. Click the EDID link for the port where you connected the monitor.

4. In the Manage EDID dialog box, click Export and save the output to a le.

5. Disconnect the monitor and establish an RGS connection to the sender.

6. In the Manage EDID dialog box, click Browse and select the EDID le you created.

7. Under Connector type (video signal), select DisplayPort (Digital).

8. Select the checkboxes for the DisplayPort connectors you want to apply the EDID le to. If you apply the

le to multiple DisplayPort connectors, RGS will be able to support dual-display congurations.

34 Chapter 6 Using RGS features

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 100 101

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 44