Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 111)

Chapter 12 Troubleshooting

105

Shaded rectangle

represents the position

of switch

Not Used (Default =Off)

BIOS Recovery

Clear Password

Clear CMOS

Not Used (Default = Off)

Figure 12-2. Configuration Switch Positions

Resetting a Lost Password

If you have forgotten the Power-on password, you can reset it using the

configuration switch on the system board.

NOTE If you have forgotten the Power-on password, your Netserver

will function normally, but you will not be able to access the

configuration settings in the Setup Utility or complete the boot

process if you reboot the Netserver.

1. Turn off power to the HP Netserver.

2. Remove the cover.

3. Move switch 3 in the configuration switch on the system board (labeled

"Clear Password") to the ON position. See Figures 12-1 and 12-2.

4. Turn on power to the Netserver and allow it to complete its startup routine.

The old password will be erased.

5. Turn off power to the Netserver.

6. Return switch 3 on the system board to the OFF position.

7. Replace the Netserver cover.

8. Turn on power to the Netserver and allow it to begin its startup routine.

9. If you wish to set a password again, press <F2> to start the Setup Utility.

10. Set the new password.

11. Choose the Exit option and save the changes to save the new password.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 139 140

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 111