Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 85)

Chapter 8 Rack Mounting the HP Netserver (4-Post)

A tension spring allows the outer-rails to compress during installation. The

outer-rails are held in place at of the front of the rack by a flat spring tab at

the rear face of the front columns. See Figures 8-2 and 8-5.

6. Repeat Steps 3 through 5 for the outer-rail on the right front and rear columns.

7. If you need to release the outer-rail assembly once it is installed into the rack,

do the following:

a. Place your finger inside the rail at the point shown by the arrow to release

the spring tab. See Figure 8-5.

b. Press in on the spring tab and pull the outer-rail assembly toward you at

the front of the rack. See Figure 8-5.

iew Rotated 90 Degrees CCW

Spring Tab

Figure 8-5. Releasing the Outer-Rail Assembly

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 139 140

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 85