Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 90)

Chapter 9 Connecting the Monitor, Keyboard, Mouse, and UPS

Connecting the UPS (Uninterruptible Power Supply)

1. If you do not have an UPS (Uninterruptible Power Supply) located in the rack,

install it before attempting to connect it to the Netserver.

2. Connect the serial cable provided between the UPS and the HP Netserver.

Refer to the user guide included with the UPS for additional information

and ensure you configure the Netserver's serial/management port correctly

in Setup (BIOS) Utility.

NOTE The HP Netserver's serial/management port must be configured

correctly or the UPS and Netserver may not work correctly.

3. If you have connected the serial cable between the two devices, turn on the

UPS.

The HP Netserver LP 1000r performs a diagnostic test when the power

switch is turned on. If an error condition occurs, note any error code

appearing on the display, then refer to Chapter 12, "Troubleshooting."

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 139 140

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 90