Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 10)

Chapter 1 Controls, Ports and Indicators

Rear Panel

The ports and connectors at the rear are listed below and shown in Figure 1-3.

• The power connector accepts a standard power cable to connect the

HP Netserver LP 2000r with a UPS or the site power source. A second power

supply for redundancy is optional. Each power supply has its own power

cord connection.

• The mouse port accepts a standard mouse with a PS/2 connector.

• The keyboard port accepts a standard keyboard with a PS/2 connector.

• The USB (2) ports are provided for devices other than the keyboard or

mouse.

• The Parallel Port is a standard parallel port, which supports Extended

Capabilities Port (ECP)/Enhanced Parallel Port (EPP).

• The Serial/Management Port is a standard serial port, which can be used for a

serial devices or management functions. For more information about

management functions, refer to the Server Management Reference Guide.

• The dedicated serial port is a standard serial port.

• The Video Port interface specifications are listed in Table A-4, "HP

Netserver Hardware Specifications" and Table A-5, "Video Display Modes"

of Appendix A, "Specifications."

• The two LAN ports (LAN A and LAN B) are for the embedded controllers

based on Intel's 82559 10/100 BaseT Fast Ethernet controller. Only LAN A

can be used for the LAN A Power On/Off remote management function.

Each LAN port has a RJ-45 LAN connector and two LEDs to indicate LAN

speed and valid connection or activity. Table 1-3 describes LAN LED

indicators. Refer to Chapter 10, "Configuring the HP Netserver," to change

configuration settings.

• The external SCSI port provides access to external SCSI devices, typically an

external SCSI tape backup device.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 145 146

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 10