Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 98)

Chapter 9 Connecting the Monitor, Keyboard, Mouse, and UPS

2. If you are not replacing the power supply module, insert the power supply

filler panel into the empty power supply bay:

a. Pinch the release lever on the filler panel and pull the lever down.

b. Slide the filler panel into the power bay. See Figure 9-7.

c. Press the release lever in until it clicks into place.

Figure 9-7. Inserting the Power Supply Filler Panel

Connecting the Uninterruptible Power Supply

1. If you have an Uninterruptible Power Supply (UPS) installed in the rack,

turn it on.

2. Connect the serial cable between the UPS and the HP Netserver.

Refer to the user guide included with the UPS for additional information.

The HP Netserver LP 2000r performs a diagnostic test when the power

switch is turned on. If an error condition occurs, refer to Chapter 12,

"Troubleshooting."

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 145 146

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 98