Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 37)

4 Installing Additional Memory

Introduction

The HP Netserver LP 2000r's main memory is implemented using four memory

slots on the system board which support up to 4 GB (1 GB x 4) of memory. The

Netserver uses only 3.3V, 168-pin, 133 MHz SDRAM DIMMs and ships with at

least one 256 MB DIMM. The embedded video controller is provided with 4 MB

standard video memory and cannot be upgraded.

NOTE Use only PC 133 (133 MHz) SDRAM DIMMs acquired from

Hewlett-Packard. The EDO DIMMs and PC 100 SDRAM

DIMMs from earlier HP Netserver models will fit into the

DIMM slots in the Netserver, but the EDO DIMMs and PC

100 SDRAM will not function properly.

To ensure you have the correct DIMMs before installation, refer to one of the

following for a list of qualified DIMMs:

• HP Order Assistant on the HP web site at:

http://www.hp.com/netserver

• HP Customer Service

Tools Required

The following tools are required to install DIMMs in the HP Netserver.

• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit

includes a static-dissipating work surface, a chassis clip lead, and a wrist

strap.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 145 146

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 37