HP VMA-series Memory Arrays Guide de l'utilisateur télécharger pdf (Page 14)

14 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A

Gateway 1 is connected to Port A on Memory Array 1, then PCIe Slot 1 on SAN Gateway 2 must

be connected to Port B on Memory Array 1.

The gigabit interfaces on each SAN Gateway, eth1 and eth2, are configured as a bonded interface

(where two interfaces act as one), eth0. HA configurations require that the management traffic and

cluster traffic both share the same physical links. A bonded network interface provides port/cable

redundancy. For more information, see the Configuring a Redundant Pair of VMA SAN Gateways

process guide at http://hp.com/go/vma-docs before you begin the installation.

Note: The Gateway Release Notes for Software OE G.5.5.1 has additional details for connecting the

HP VMA SAN Gateway with the HP VMA-series array. Also, configuration and turning

information per host operation system. Read these notes for this and other setup and configuration

information at http://hp.com/go/vma-docs.

Note: If you are planning to install and setup dual gateways as a redundant pair for High Availability,

refer to the Configuring a Redundant Pair of VMA SAN Gateways process guide at http://hp.com/

go/vma-docs before you begin the installation.

Figure 1.2 Redundant gateway pair of VMA-series SAN Gateways with 2 HP VMA-series Memory Arrays, Highly Available

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 82 83

Pas de commentaire

HP VMA-series Memory Arrays Guide de l'utilisateur Page 14